Too bad the TV broadcasts rarely show when anyone runs on to the field.
Too bad the TV broadcasts rarely show when anyone runs on to the field.
Nice, I have much the same setup in my house!
I visited the recently Passive House certified student residence buildings at the University of Victoria, and the heat recovery there is quite interesting. Passive House requires a very low heating load, so they recover all the heat they can from the commercial kitchen (the presence of which is rare in a Passive House because of high ventilation requirements) processes such as ventilation hoods and refrigeration systems and put it into the DHW system.
They had to get a bit creative with the design, but it’s really not that complicated. More just not doing things the way they’ve always been done.
I think there’s a lot of opportunity for reducing wasted energy in many buildings. Even the term “waste heat” is indicative that energy is typically exhausted when it could be used for space or water heating. Obviously mechanical modifications would be needed, sometimes extensive, but it’s a good option for reducing energy use.
“Ground, it’s Fred. Off to work. Request taxi to the road.”
“Fred, Ground, roger. Taxi bravo three, left on Juliet, cross runway 34 right, right on foxtrot to the gate. I’ll let security know you’re on the way. Have a good day.”
It starts early in the design process. But at that stage, it would be best to pause installation, have a mechanical engineer do the mechanical design (including equipment selection) based on an energy model and install the recommended equipment.
I work in building science. It’s obscene how little actual design and quality control goes into residential homes.
The typical design is just one step above being illegal, and people are often scared off of doing anything more than that by the threat of increased cost. However, they don’t realize that they pay for it either way; either on their mortgage, or on utilities. Only one of those you can actually own in the end.
I perhaps haven’t played since the ground handling update, but tailwheel aircraft never behaved like actual tailwheel aircraft. Their steering seemed coupled to the rudder, similar to nose wheel aircraft, instead of having any of the momentum effects of a tailwheel with just a loose steering influence.
I believe the airport was a mid-sized towered airport in Idaho. I forget exactly which though. I selected it as my home base for Neofly because of the scenery and was disappointed when it seemed rather incomplete.
I feel it would’ve been ahead of where it was if it took the aviation side of FSX and paired it with the scenery, weather, and online features of MSFS.
I had FS2020 working well with yoke and pedals and a streamdeck, but it just didn’t feel like a complete sim. Many airports just weren’t there or had incorrectly labeled taxiways, which threw off taxi instructions and obviously made real world charts useless. Tailwheel aircraft didn’t really work properly at all.
Sure, it was a beautiful sim, but was quite lacking on the technical side. I’m doubtful a whole new product is going to solve any of those issues.
I was going to also post the direct AMA link, but the OP is a nice concise summary of many of the key discussions, provided without having to go to that site. I’d recommend reading that instead and follow links as you see fit.
Sorry, four of the power to ethernet plugs. You put one near your router to essentially supply internet to your house’s electrical circuits, then distribute the others where you need them, such as office, living room if you want to connect a TV or console, etc.
I had a set of four for getting ethernet around the few places I rented. There was maybe the odd quality decrease when there was a lot of electrical load, but they worked great otherwise.
Politicians can’t get their back pats if there’s no one to pat their backs.
Yeah, I use a hop spider and whirlfloc with the whirlpool arm to limit the solids transferred and it works quite well.
You should be able to get a bit more volume if you transfer using the pump instead of the spigot. Not a whole lot but makes a difference on the lower volume brews. You can even tilt it a bit toward the pump inlet to get the last little bit out.
The cost of doing business.
Income-based fines should really be more commonplace.
“Our Computer”
What’s your alternative for access and supplies to many remote communities?
Oh man, I remember a Philips mp3 player I had for the longest time as a kid. You could hear the little clicks of the hard drive. Lost it on a hike, unfortunately.
Right, hopefully G100UL can replace 100LL reasonably quickly, but there’s a big difference between “commercially available” and actually available. I imagine it will be quite some time until it’s commonplace for GA aircraft, unfortunately.
A mall that’s only random clothes, shoes, and jewellery stores surrounded by an ocean of parking lot is very unattractive.
As you say, a mall with actually useful stores, like grocery, pharmacy, perhaps a restaurant or two (not chain fast food), etc, with residential units on top or very close to constitutes more of a community than a mall and is very likely to be sustainable versus the former.